Door use, guarantee and storage instructions

The products contained in this technical manual are manufactured according to the manufacturer’s technical specifications. The manufacturer guarantees the repair and, if he considers necessary, the replacement of any product which have been shown to be defective within a 30 -days period established under Article 342 of the Spanish Code of Commerce. Under no circumstances the guarantee shall be in force after a year starting from the date of the product manufacturing. The guarantee covers both; labor and any other materials or spare parts used to repair or to replace the product. The technicians’ travel and accommodation expenses will be at the buyer’s expense. A preventive maintenance of the product shall be made in order to renew the former guarantee, regardless whether the product has been fitted or in storage. This guarantee renewal will be only valid if the maintenance is carried out by the manufacturer or staff duly authorized by him. The frequency of this preventive maintenance is fixed according to the number of cycles to be performed by a door in accordance with the following schedule: We have to consider the following: 1.- Levels of use higher than 60.000 cycles annually are understood to be special, so the frequency of maintenance or the improvements to be made will be determined by the manufacturer’s technical department in each case. 2.- The level of maintenance may vary according to the accessories fitted to the product after its manufacture. Under no circumstance the manufacturer will assume responsibilities for defects due to: - Inadequate fitting of the product, that is to say, not fitting the product according to the manufacturer’s instructions (see instructions for assembly); - The use of accessories not approved by the manufacturer (see Technical Manual); - Inadequate storing or exposure of the products to atmospheric agents during transport or handling when the products are being collected by the carrier or, where applicable, when the delivery note is being signed. LEVELS OF MAINTENANCE WITH FITTED ACCESSORIES Doors fitted with the following accessories are considered standard -Handle- Cylinders -Vision panel - Lock If the following accessories are fitted, the manufacturer recommends a more frequent maintenance - Door-closer -Electro-magnets -Selectors Doors fitted with the above fittings require reinforcement plates in the door leaf and it will be required to duplicate the maintenance frequency specified in the annual cycle frequency table. For fire doors, that perform between 50,000/80,000 cycles annually or those which are exposed to extreme use conditions such as the case of schools, universities, hospitals, supermarkets, etc., Puertas Padilla requires the following improvements (detailed in the Technical Manual); DOORS OF INTENSIVE OR HEAVY USE For single leaf doors; in order to improve the mechanical condition, it is necessary a higher thickness of the sheet, at least 1mm. In case of requirement of accessories, it is extremely important that the fixing and the installation of the accessories are able to support the mentioned level of use (see Technical Department). For double leaf doors; in order to improve the mechanical conditions of the set, it is necessary to increase the thickness sheet of the leaf, at least 1mm. In order to allow the proper operation of the door in the course of time, It will be also necessary the installation of door-closers of 5CEN level. In these cases, the maintenance will be, at least, every three months; if necessary, it can be increased depending on the accessories and the degree. LEVEL User´s Intensive Heavy CYCLES Less than 15.000 cycle annually Up to 30.000 cycles annually Between 30.000 a 60.000 cycles annually FREQUENCY Annual Biannual Quarterly NORMAS DE USO Y GARANTÍA INSTRUCTIONS FOR USE AND GUARANTEE ( Ed_ 07/06 ) 4 www.baygar.com