Lámina de aislamiento acústico U-Boot Silence

6 Impact noise Airborne noise Specifications Laboratory Tests Implementation of sound insulation of slabs such as "U-Boot Beton®" from noise of footsteps and airborne, made with the technique of the "floating floor" through the use of the sound insulation mantle "U-Boot Silence" by Daliform Group made, of 100% closed cell polyolefin chemical cross-linked polyethylene, density 35 kg/m.3, thickness 8 mm, low elastic module, color yellow The product comes in rolls of H 1.5 m x L 60 m. The installation must be performed aligning the heads of the side flaps and sealing of joints by applying the adhesive strip “Rotocell AD”. The surface must be perfectly superimposed to the appropriate perimeter buffering "Superfascia AD." The layer on which to lay the product must be perfectly dry, clean and free of bumps. On top of the insulation layer is laid a concrete screed, at least 4 cm thick, on which will then be made the flooring planned. The excess of insulating material present along the perimeter will be trimmed only once the floor is finished, masked by the application of the baseboard, which will be detached from the floor in order not to determine "sound transmission". Empirical evidence on the level of sound insulation have been obtained by laboratory tests, carried out according to UNI EN ISO 1403:2006, 140-6:2000, 717-1:2007, 717-2:2007 standards, on a plate slab lightened with the construction system U-Boot Beton®. The results of unfinished slabs, are better than traditional masonry systems both in terms of airborne noise and by impact. Even more important is the outcome of the acoustic tests of the slabs lightened with U-Boot Beton® on which was created a floating floor with a soundproofing mantle U-Boot Silence, which showed values ​corresponding to Class I .(UNI 11367:2010) The information contained in this catalogue could be changed. Before placing an order, request a confirmation or updated information from the DALIFORM GROUP, which reserves the right to make changes at any moment without notice. In consideration of recycled material, it is specified that there are tolerance margins caused by environmental factors. To contact the technical office: Tel. +39 0422 208350 - tecnico@daliform.com To obtain updated technical cards, support material, new photos and case studies, go to www.daliform.com The technical consultancy is only valid for the Daliform Group construction systems. www.baygar.com